User Guide

DVB-H interface

RM-100 has an integrated DVB-H receiver. The receiver is built into a module form-factor located in upper

block of RM-100. The DVB-H receiver consists of 2 key components, RFIC and BBIC. It is able to receive 6, 7 or

8MHz (channel width depending on used standard in different countries) DVB-H transmissions over

470-750MHz band. The receiver decapsulates IP packets (e.g. audio and video data) from the stream and

forwards them to the application processor. The module contains all needed DVB-H receiver functions

excluding antenna. Antenna consists of antenna element and matching circuitry. Matching circuitry is

controlled via DVB-H receiver.The DVB-H module is controlled by OMAP1710SS with SPI interface that is

common with displays. The DVB-H module is set on and off by DVB_H_Ena signal that is controlled by OMAP

1710SS. DVB-H activity signal is used for synchronizing SD memory card operation during DVB-H reception.

RM-100

System Module Nokia Customer Care

Issue 2 COMPANY CONFIDENTIAL Page 10 –15