User Guide

6. Follow the DVB-H troubleshooting flowchart.

Table 16 Pass/Fail Failure codes

Result Description Action

0x1

C Connection to RF failed

Swap upper PWB.

0x2

C Connection to EEPROM failed

Swap upper PWB.

0x3

C Connection to antenna DAC

failed

Swap upper PWB.

0xFD No connection to DVB-H Module Replace hinge cables.

0xF2 Another test is ongoing Restart phone and run the self

test again.

DVB-H RX testing

Test setup – Option 1 with RF coupler SA-100

Steps

1. Measure RF input level with CW signal. Connect the phone to service concept, consisting of CU-4, SS-62,

FS-17 and SA-100, as shown below (more details in Service tools and concepts (page ).

2. CW signal from Signal Generator is fed to GSM connector of the SA-100.

3. Start

Phoenix

and set Operation mode to Local.

Figure 82 RM-100 DVB-H RXtest set-up Option 1 – RF coupler

RM-100

Nokia Customer Care TV troubleshooting

Page 9 –6 COMPANY CONFIDENTIAL Issue 2