User Guide

2. Make the selection as shown in the box below:

3. Press Start.

Now you should see the following box:

4. Measure the ouput power via the WLAN/ BT RF connector with a power meter.

For Power level 1: 17.5dBm, you shall see +16dBm (+/- 1dB).

5. Repeat steps 2 to 4 for the other power level.

You shall see the following values:

• Power output level 2 = 14dBm (+/- 1dB)

• Power output level 3 = 9dBm(+/- 1dB)

• Power output level 4 = 6dBm (+/- 1dB)

Change to continuous mode if using the other power levels.

6. Now repeat the same exercise for Data Rate = 54Mbps.

You shall see the following power levels:

RM-100

RF Troubleshooting and Manual Tuning Guide Nokia Customer Care

Issue 2 COMPANY CONFIDENTIAL Page 7 –57