User Guide

ManualsBrandsNokia ManualsCell PhoneN92

231

232

233

234

235

236

237

238

239

240

Steps

1. Connect a module jig to a computer.

Make sure that you have a PKD-1 dongle connected to the computer parallel port.

2. Connect a DC power supply to a product-specific module jig.

Note: When repairing or tuning a transmitter, use an external DC supply with at least 3 A current

capability.

Set the DC supply voltage to 3.8 V.

3. Connect an RF cable between the RF connector of the product-specific module test jig and measurement

equipment or alternatively use a 50 ohms (at least 2 W) dummy load in the module test jig RF connector;

otherwise GSM or WCDMA PA may be damaged.

Note: There are three antenna connectors in the module jig:

• one for GSM

• one for WCDMA

• one for Bluetooth and WLAN* (* = if applicable)

Make sure that all connections are made to the correct RF connector.

Normally a spectrum analyser is used as measurement equipment.

Note: The maximum input power of a spectrum analyser is +30 dBm.

To prevent any damage, it is recommended to use 10 dB attenuator on the spectrum analyzer input.

4. Set Tx on.

i Place the phone module to the test jig and start

Phoenix

service software.

ii Initialize connection to the phone (with FPS-10 use FBUS when using a DAU-9S cable and a COMBOX

driver).

iii Choose File→Open Product→xx-x* (* = type designator of the phone) or File→Scan Product. .

iv From the toolbar, set Operating mode to Local.

Alternative steps

• EGSM900/GSM1800/GSM1900 troubleshooting

i Choose Testing→GSM→RF Controls.

ii In the

RF Controls

window:

• Choose Band: GSM900 or GSM1800 or GSM1900 (Default = GSM900).

• Set Rx/Tx channel in the following way:

• GSM900: 37

• GSM1800: 700

• GSM1900: 661

• Set Active unit to Tx (Default = Rx).

• Set Operation Mode to Burst (Default = Burst).

• Set Edge to Off (Default).

• Set Tx Data Type to All 1 (Default = All 1).

• Set Tx PA Mode to High (Default).

• Set Tx Power Level in the following way:

• GSM900: 5 (Default = 19)

RM-100

Nokia Customer Care RF Troubleshooting and Manual Tuning Guide

Page 7 –18 COMPANY CONFIDENTIAL Issue 2