User Guide

WCDMA Rx chain activation for manual measurement
Steps
1. Start Phoenix service software.
2. Choose Testing→WCDMA→Rx Control .
3. In the
Rx Control window:
Figure 60 Rx Control window
• Set AGC Mode to Algorithm.
• Set Channel to 10700.
• Set AFC Algorithm to OFF (Default = OFF).
Next actions
When settings are ready, click Start to activate them.
If settings are changed later on (for example, you give a new channel number), you will need to click Stop
and Start again.
Note: Clicking Stop also disables Tx Control if that was active!
WCDMA RSSI measurement
Prerequisites
WCDMA Rx must be activated before RSSI can be measured. See WCDMA Rx chain activation for manual
measurement (page 7–13).
Steps
1. Start
Phoenix service software.
2. Choose Testing→WCDMA→Rx Power Measurement .
RM-100
RF Troubleshooting and Manual Tuning Guide Nokia Customer Care
Issue 2 COMPANY CONFIDENTIAL Page 7 –13
Copyright © 2007 Nokia. All rights reserved.