User Guide

8. If the values are OK, click Yes to save the values.

9. Close the tuning window.

Alternative steps

• From the "Operating mode" dropdown menu, set mode to "Local".

• From the Tuning menu, choose WCDMA -> Rx AGC Alignment.

• Click Start.

• Check the “Tune Rx Band Response” checkbox and click Tune.

• Setup the signal generator according to the values in the pop-up window:

Frequency list: 2113.4 MHz, 2141 MHz and 2166.6 MHz

Dwell time: 2 ms

Sweep control: Automatic continuous sweep

Level: –48 dBm + cable and adapter attenuations

Modulation: FM

Deviation: 500 kHz

Modulation frequency: 50 kHz

• Click OK.

• Check that the “Rx chain” , “Low freq.” and “High freq.” values in the Tuning Results window are within the

limits presented in the following table.

RM-42

RF Troubleshooting and Manual Tuning Guide Nokia Customer Care

9241872 (Issue 1) Company Confidential Page 7–47