User Guide

3. To add a new connection, click Add.

4. Select Manual mode, and click Next to continue.

If you want to create the connection using the Connection Wizard, connect the tools and a phone to your

PC. The wizard will automatically try to configure the correct connection.

Figure 16 Select mode: Manual

i For an FPS-10 flash prommer with a USB Connection, choose the following connection settings:

• Media: FPS-10 USB

• DEVICE_INDEX: 0

• SERIAL_NUM: See Serial No from the label attached to the bottom of FPS-10

• ACTIVE_MEDIA: USB

ii For an FPS-10 flash prommer with a LAN connection, choose the following connection settings:

• Media: FPS-10 TCP/IP

• NET_SERV_NAME: Click Scan.... Choose your own FPS-10 device based on the correct MAC address.

See Serial No from the label attached to the bottom of your FPS-10.

• PORT_NUM: Use the default value, and click Next.

• PROTOCOL_FAMILY: Use the default value, and click Next.

• SOCKET TYPE: Use the default value, and click Next.

• TX_BUFFER_SIZE: Use the default value, and click Next.

• RX_BUFFER_SIZE: Use the default value, and click Next.

iii For a plain USB connection, choose the following connection settings:

Note: First connect the DKE-2 cable between the PC USB port and phone.

• Media: USB

RM-135

Nokia Customer Care Service Software Instructions

Page 2 –18 COMPANY CONFIDENTIAL Issue 1