Nokia Customer Care RH-29 Series Cellular Phones 5 - Disassembly Instructions Issue 1 05/2004 Copyright © 2004 Nokia Corporation Company Confidential Page 1
RH-29 Company Confidential 5 - Disassembly Instructions Nokia Customer Care Table of Contents Page No Disassembly Instructions. ......................................................................................................................
Company Confidential RH-29 5 - Disassembly Instructions Nokia Customer Care Disassembly Instructions See also the video clips on care point. If not already done protect window with a film. Press the Release Button before pulling down the Battery Cover. Place the device in to the SS-33 Opening Tool. Now, press down the Keymats from the top side carefully. Remove A-Cover with Grip. Also protect the inner side of the Window with a film.
RH-29 Company Confidential 5 - Disassembly Instructions Separate the Grip from A-Cover. Remove both Keymats. Unscrew the six Torx Plus® size 6 screws. For assembly, the reverse order and a Torx Plus 27Ncm has to be used. Nokia Customer Care ® Now, take away the LCD-Shield. driver with a torque of After protecting the LCD Module with a film, remove the Module from its guidance carefully. Place the SRT-6 under the upper part of the connector Take care not to damage the surrounding components.
Nokia Customer Care Company Confidential RH-29 5 - Disassembly Instructions Torx screwdriver can be used to push down the Earpiece from its guidance. Lift the UI-PWB a bit as shown in the picture. Turn the UI- PWB a bit and take it off from the guiding pin of the Center Frame carefully. Remove the Engine Module. Remove the Power Key. Remove the Antenna. DC-Plug can be used to remove the DC-Jack from its guidance. Remove the SM Jack by using tweezers as a lever.
RH-29 Company Confidential 5 - Disassembly Instructions Nokia Customer Care Remove the Vibra Motor. Remove the IHF-Lid. IHF Speaker is attached with adhesive gasket to its Guidance. Use always SRT-6 as a level to remove the Speaker. Tweezers can be used to remove the MMC Card Shield. Place tweezers between B-Cover’s edge and the respective snaps of the shield and press down the Shield carefully.
