Nokia Bluetooth Speakers MD-5W 2 3 4 5 6 7 8 8 9 10 11 12 14 13 Issue1
DECLARATION OF CONFORMITY Hereby, NOKIA CORPORATION declares that this MD-5W product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/phones/ declaration_of_conformity/. © 2007 Nokia. All rights reserved. Reproduction, transfer, distribution or storage of part or all of the contents in this document in any form without the prior written permission of Nokia is prohibited.
Introduction Congratulations on your purchase. With Nokia Bluetooth Speakers MD-5W you can listen to music from your compatible phone or music device and enjoy the highquality audio. You can also use the speakers as a speakerphone thanks to the integrated microphone. You can connect the speakers to a compatible device using Bluetooth wireless technology or the supplied cable. Read this user guide carefully before using the speakers.
There may be restrictions on using Bluetooth technology in some locations. Check with your local authorities or service provider. Getting started Parts Chargers The speakers contain the parts shown on the title page: indicator light (1), rewind key (2), power key (3), play/pause key (4), answer/end key (5), fast forward key (6), microphone (7), speakers (8), volume down key (9), stereo widening key (10), volume up key (11), power connector (12), battery compartment (13), and audio input (14).
Install AA batteries When you use batteries, alkaline batteries are recommended. To install the batteries, ensure that the speakers are off, and open the cover of the battery compartment by pushing the lower part of the cover and pulling the cover up. Place the batteries as indicated in the compartment, and push the cover until it snaps into place. During long periods where the speakers are not used, remove the batteries to prevent damage from battery leakage.
1. Ensure that the speakers are off and that the phone is on. 2. Press and hold the power key until the blue and red indicator lights start to alternate. 3. Activate the Bluetooth feature on the phone, and set it to search for Bluetooth devices. 4. Select the speakers from the list of found devices. 5. Enter the Bluetooth passcode 0000 to pair and connect the speakers to the phone. In some phones you may need to make the connection separately after pairing.
player such as a mobile phone with a music player feature or other music player device. To use the music functions, connect the compatible device to the speakers using Bluetooth wireless technology. The compatible music player should support the A2DP Bluetooth profile. If you use a cable connection, you can only adjust the volume of the speakers; to control music, use the keys on your music player. If you answer or make a call while listening to music, playing is paused until the call ends.
If your phone supports voice dialing with the speakers, press the answer/end key when no call in progress, and proceed as described in the user guide of your phone. To answer or end a call, press the answer/end key. If you do not want to answer the call, press and hold either volume key. To switch an ongoing call from the speakers to a compatible phone, press and hold either volume key. To switch the call back to the speakers, press the power key.
devices, damage batteries, and warp or melt certain plastics. • Do not store the device in cold areas. When the device returns to its normal temperature, moisture can form inside the device and damage electronic circuit boards. • Do not drop, knock, or shake the device. Rough handling can break internal circuit boards and fine mechanics. • Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the device. • Do not paint the device.
