User Guide

• Power supply

• Product specific module jig

• Cables: XRF-1 (RF cable), USB cable, GBIP cable and DAU-9S

• Signal analyser (TX), signal generator (RX) and RF-splitter

one device including all.

Figure 15 Auto tuning concept with CMU200

Phoenix preparations

Install the phone specific data package, for example

RA-6_dp_1.78_sw_sh3.26.exe

. This defines phone specific

settings..

Auto tuning procedure

1 Make sure the phone (in the jig) is connected to the equipment. Else, some menus will not be shown in

Phoenix.

2 To go to autotune, select

Tuning (Alt-U)

Auto-Tune (Alt-A)

from the menu.

3 Start autotuning, clicking the

Tune

button.

Antenna line component changing

1 Check the RF test connector (X7501)

2 Check the antenna contact springs (X7570, X7572 and X7573)

RA-6

RF troubleshooting

Issue 1 COMPANY CONFIDENTIAL Page 4 –7