User Guide

Figure 27 WCDMA RX generator settings

Note: Frequency for band WCDMA II 1961.0MHz, V 882.6MHz, VIII 943.4MHz

2. From the Phoenix testing menu, select WCDMA→RX Power measurement

3. In the RX power measurement window, make the following settings:

Figure 28 Phoenix WCDMA RX power measurement window

4. Click Start to perform the measurement.

Note: WCDMA RSSI measurement is accurate only with WCDMA modulated signal.

Transmitter Troubleshooting

General instructions for transmitter (TX) troubleshooting

Please note the following before performing transmitter tests:

•

TX troubleshooting requires TX operation.

•

Do not transmit on frequencies that are in use.

•

The transmitter can be controlled in local mode for diagnostic purposes.

•

The most useful Phoenix tool for GSM transmitter testing is “RF Controls”, in WCDMA transmitter testing

the best tool is “TX Control”.

•

Remember that re-tuning is not a fix! Phones are tuned correctly in production.

Note: Never activate the GSM or WCDMA transmitter without a proper antenna load. Always connect

a 50 Ω load to the RF connector (antenna, RF-measurement equipment or at least a 2 W dummy

load); otherwise the GSM or WCDMA Power amplifier (PA) may be damaged.

GSM transmitter troubleshooting

Steps

1. Set the phone to local mode.

2. Activate RF controls in Phoenix (Testing→GSM→Rf Controls ).

Make settings as shown in the figure:

RM-412; RM-413

RF Troubleshooting

Page 4 –10 COMPANY CONFIDENTIAL Issue 1