User guide

3. Select the device with which you want to connect.
4. If the other device requires pairing before data can be
transmitted, a tone sounds, and you are asked to enter
a passcode. The same passcode must be entered in
both devices.
When the connection is established, Sending data is
displayed.
Pair devices
To pair with compatible devices and view your paired
devices, in the main view of Bluetooth connectivity, scroll
right.
Before pairing, create your own passcode (1 to 16 digits),
and agree with the owner of the other device to use the
same code. Devices that do not have a user interface have
a factory-set passcode. The passcode is used only once.
1. To pair with a device, select Options > New paired
device. Devices that are within range are displayed.
2. Select the device, and enter the passcode. The same
passcode must be entered on the other device as well.
3. Some audio enhancements connect automatically to
your device after pairing. Otherwise, scroll to the
enhancement, and select Options > Connect to
audio device.
Paired devices are indicated by
in the device search.
To set a device as authorised or unauthorised, scroll to the
device, and select from the following options:
• Set as authorised — Connections between your
device and the authorised device can be made without
your knowledge. No separate acceptance or
authorisation is needed. Use this status for your own
devices, such as your compatible headset or PC or
devices that belong to someone you trust.
indicates
authorised devices in the paired devices view.
• Set as unauthorised — Connection requests from this
device must be accepted separately every time.
To cancel a pairing, scroll to the device, and select
Options > Delete.
If you want to cancel all pairings, select Options > Delete
all.
Receive data using Bluetooth
connectivity
When you receive data through Bluetooth connectivity, a
tone sounds, and you are asked if you want to accept the
message. If you accept,
is displayed, and the item is
placed in the Inbox folder in Messaging. Messages received
through Bluetooth connectivity are indicated by
.
Tip: If your device notifies you that the memory is
full when you try to receive data through Bluetooth
connectivity, change memory card as the memory
where the data is stored.
Block devices
Select Menu > Ctrl. panel > Connectivity >
Bluetooth.
To block a device from establishing a Bluetooth
connection to your device, open the Paired devices tab.
55
Connectivity