User Guide

i If the values are OK, click Yes to save the values.

8. Close the tuning window.

Alternative steps

• From the Operating mode drop-down menu, set mode to Local.

• Choose Tuning→WCDMA→Rx AGC Alignment.

• Click Start.

• Check the Tune Rx Band Response check box and click Tune.

• Setup the signal generator according to the values in the pop-up window:

Frequency list: 2113.4 MHz, 2141 MHz and 2166.6 MHz

Dwell time: 2 ms

Sweep control: Automatic continuous sweep

Level: –48 dBm + cable and adapter attenuations

Modulation: FM

Deviation: 500 kHz

Modulation frequency: 50 kHz

• Click OK.

• Check that the Rx chain , Low freq. and High freq. values in the

Tuning Results

window are within the

limits presented in the following table.

RM-10;RM-24

RF Troubleshooting and Manual Tuning Guide Nokia Customer Care

Issue 1 COMPANY CONFIDENTIAL Page 7 –43