User Guide

Steps

1. From the Operating mode drop-down menu, set mode to Local.

2. Choose Tuning→WCDMA→Rx Band Response Calibration.

3. Click Start and Tune.

4. Setup the signal generator to correspond the values in the pop-up window:

Frequency: 2113.4 MHz

Level: –48 dBm + cable and adapter attenuations

Modulation: FM

Deviation: 500 kHz

Modulation frequency: 50 kHz

5. Click OK.

6. Change frequency to

2166.6

MHz and click OK.

7. Check that the tuned values are within the limits specified in the following table :

Min Max

Frequency compensation low -5 +5

Frequency compensation high -5 +5

RM-10;RM-24

Nokia Customer Care RF Troubleshooting and Manual Tuning Guide

Page 7 –42 COMPANY CONFIDENTIAL Issue 1