User Guide

Figure 16 Select mode: Manual

i For an FPS-10 flash prommer with a USB Connection, choose the following connection settings:

• Media: FPS-10 USB

• DEVICE_INDEX: 0

• SERIAL_NUM: See Serial No from the label attached to the bottom of FPS-10

• ACTIVE_MEDIA: USB

ii For an FPS-10 flash prommer with a LAN connection, choose the following connection settings:

• Media: FPS-10 TCP/IP

• NET_SERV_NAME: Click Scan.... Choose your own FPS-10 device based on the correct MAC address.

See Serial No from the label attached to the bottom of your FPS-10.

• PORT_NUM: Use the default value, and click Next.

• PROTOCOL_FAMILY: Use the default value, and click Next.

• SOCKET TYPE: Use the default value, and click Next.

• TX_BUFFER_SIZE: Use the default value, and click Next.

• RX_BUFFER_SIZE: Use the default value, and click Next.

iii For a plain USB connection, choose the following connection settings:

Note: First connect the DKU-2 or CA-53 USB cable between the PC USB port and phone.

• Media: USB

5. To complete the configuration, click Finish.

6. Click the connection you want to activate. Use the up/down arrows located on the right hand side to move

it on top of the list, then click Apply.

Figure 17 Connections list

The connection is activated, and it can be used after closing the

Manage Connection

window.

The connection information is shown at the right hand bottom corner of the screen.

RM-208

Nokia Customer Care Service Software Instructions

Page 3 –18 COMPANY CONFIDENTIAL Issue 1