User Guide

ManualsBrandsNokia ManualsCell PhoneE65

231

232

233

234

235

236

237

238

239

240

Modem section consists of RAP3GS ASIC with NOR FLASH and DDRAM memory as the core. Memory package

POP2 is stacked on to RAP3GS. RAP3GS supports cellular protocols of WCDMA (3GPP R-4) and GSM (minimum

EDGE glass 10, GPRS phase2). Modem DDRAM memory have 128Mbits of memory and NOR flash have 128Mbits

of memory. RAP3G operates with the system clock of 38.4 MHz, which comes from the VCTCXO.

Application section includes application processor ASIC with DDR/NAND combo memory as the core.

Application processor uses 19.2MHz clock, which comes from the RAP3GS divided by two from the 38.4 MHz

system clock.

Application processor (OMAP1710) is also called as an application ASIC because it is processing application

SW and handles the UI SW. It consists of OMAP3.3 and peripheral subsystems like display- and keyboard driver

blocks.

Absolute maximum ratings

Signal Min Nom Max

Uni

Notes

Battery voltage (idle) -0.3 +4.5 V Battery voltage maximum value is

specified during charging is active

Battery voltage (Call) +3.2 +4.3 V Battery voltage maximum value is

specified during charging is active

Charger input voltage -0.3 +20 V

Back-Up supply voltage 0 2.5 2.6 V Maximum capacity of the backup

power supply assumed to be 4 µAh.

Phone modes of operation

Mode Description

NO_SUPPLY

(dead) mode means that the main battery is not

present or its voltage is too low (below VILMA master

reset threshold) and that the back-up battery

voltage is too low.

BACK_UP

The main battery is not present or its voltage is too

low but back-up battery voltage is adequate and the

32kHz oscillator is running (RTC is on).

PWR_OFF

In this mode (warm), the main battery is present and

its voltage is over VILMA master reset threshold. All

regulators are disabled, PurX is on low state, the RTC

is on and the oscillator are off.

RESET

RESET mode is a synonym for start-up sequence.

RESET mode uses 32kHz clock to count the REST mode

delay (typically 16ms).

SLEEP

SLEEP mode is entered only from PWR_ON mode with

the aid of SW when the systems activity is low. There

are in principle three different sleep modes:

• Helen3 sleep

• RAP3GS sleep

• Helen3 and RAP3GS sleep (deep sleep)

RM-208

Nokia Customer Care System Module

Page 9 –6 COMPANY CONFIDENTIAL Issue 1