User Guide

WCDMA RX chain activation for manual measurement

Prerequisites

Make the following settings in Phoenix service software:

Setting WCDMA

WCDMA

VIII

WCDMA V

Phoenix channel 10700 9800 3012 4408

Signal generator to

antenna connector

2141.0

MHz

1961.0

MHz

943.4

MHz

882.6

MHz

Note: The phone has two WCDMA bands. The testing and tuning procedures are same for both bands.

Just select band I or VIII (RM-437), II or V (RM-449), I or V (RM-450).

Steps

1. Via Phoenix Testing menu, choose WCDMA/RX Control.

2. In the RX control window, make the following settings:

3. Click Start to activate the settings.

If the settings are changed later on (for example, change of channel) you have to click Stop and Start

again.

Note: Clicking Stop also disables TX control if it was active.

4. Set the following RF generator settings:

RM-437; RM-449; RM-450

RF troubleshooting

Issue 1 COMPANY CONFIDENTIAL Page 4 –9