User Guide

3. Specify AP for the WLAN AP inside the SB-7: go to the Application – Tools – Settings – Connection –

Access points -menu. Select Options and then select New access point and then set the following

information:

a Connection name: default

b Data bearer: Wireless LAN

c WLAN network name: default

d Network status: Public

e WLAN network mode: Infrastructure

f WLAN security mode: Open network

g WLAN security settings: leave it as it is

h Homepage: 192.168.0.51

4. Go back to the top level by pressing Back – Back – Exit – Back – Exit.

5. Go to the Application –menu and select Web.

6. Open the Options –menu and select Settings and General.

a Define Access point – User defined and select Default from the pop-up menu.

b Define Homepage – User defined and enter 192.168.0.51.

7. Go back to the top level by pressing Back – Back – Exit – Exit.

8. Go to the Application –menu and select Web. Ignore the error message: Web, no gateway reply - this

is due to the fact that SB-7 is not connected to the internet.

9. Press Application button until you can select Standby.

10. Go to the Application –menu and select Connectivity – Conn.mgr. and select Active data

connections. Now you should see the connection named default and below the name there should be

time running. Or if you came very fast to this menu after turning browser on, there may be indication

of connecting below the name default. If so, wait until time starts to run below the name default.

Select these connections from the Options –menu by selecting Details.

a Status should show: Conn. (inactive… or Conn. (active).

b Signal should show: Medium (50%). This field can also be Strong and percent number can also be

higher.

11. WiFi indicator top of the screen should be ON when connected to the AP

RM-437; RM-449; RM-450

BB Troubleshooting

Page 3 –28 COMPANY CONFIDENTIAL Issue 1