User guide
Table Of Contents
- Nokia E52 User Guide
- Contents
- Safety
- Find help
- Get started
- Nokia E52 – The basics
- Personalisation
- New from Nokia Eseries
- Messaging
- Phone
- Internet
- Travelling
- Positioning (GPS)
- Maps
- Maps overview
- View your location and the map
- Map view
- Change the look of the map
- About positioning methods
- Find a location
- View location details
- Save places and routes
- View and organise places or routes
- Send places to your friends
- Share location
- Synchronise your Favourites
- Get voice guidance
- Drive to your destination
- Navigation view
- Get traffic and safety information
- Walk to your destination
- Plan a route
- Use the compass
- Nokia Office Tools
- Media
- Connectivity
- Security and data management
- Settings
- General settings
- Telephone settings
- Connection settings
- Access points
- Packet data (GPRS) settings
- WLAN settings
- Advanced WLAN settings
- WLAN security settings
- WEP security settings
- WEP key settings
- 802.1x security settings
- WPA security settings
- Wireless LAN plugins
- Session initiation protocol (SIP) settings
- Edit SIP profiles
- Edit SIP proxy servers
- Edit registration servers
- Configuration settings
- Restrict packet data
- Application settings
- Shortcuts
- Glossary
- Troubleshooting
- Green tips
- Product and safety information
- Copyright and other notices
- Index
Q: How do I check the signal quality of my WLAN connection?
Select Menu > Ctrl. panel > Connectivity > Conn. mgr. and Active data
connections > Options > Details. If the signal quality is weak or moderate, you may
encounter connection problems. Try again closer to the access point.
Q: Why do I have problems with the security mode?
A: Check that you have configured the security mode correctly, and that it is the same
that the network uses. To check the security mode the network uses, select Menu >
Ctrl. panel > Connectivity > Conn. mgr. and Active data connections > Options >
Details.
Check also the following: you have the correct WPA mode (preshared key or EAP), you
have disabled all EAP types that are not needed, and all the EAP type settings are correct
(passwords, user names, certificates).
Q: Why can’t I select a contact for my message?
A: The contact card does not have a phone number, an address, or an e-mail address.
Select Menu > Contacts, and edit the contact card.
Q: The note Retrieving message is shown briefly. What is happening?
A: The device is trying to retrieve a multimedia message from the multimedia messaging
centre. This note is shown if you have selected Menu > Messaging and Options >
Settings > Multimedia message > Multimedia retrieval > Always automatic.
Check that the settings for multimedia messaging are defined correctly and that there
are no mistakes in phone numbers or addresses.
Q: How can I end the data connection when the device starts a data connection
again and again?
A: The device may be trying to retrieve a multimedia message from the multimedia
message centre. To stop the device from making a data connection, select Menu >
Messaging and Options > Settings > Multimedia message > Multimedia
retrieval > Manual to have the multimedia messaging centre save messages to be
retrieved later, or Off to ignore all incoming multimedia messages. If you select
Manual, you receive a notification when there is a new multimedia message that you
can retrieve in the multimedia message centre. If you select Off, the device does not
make any network connections related to multimedia messaging.
182 Troubleshooting