User guide

Password — A password may be needed to make a data connection and is usually
provided by your service provider.
Authentication — Select Secure to always send your password encrypted or
Normal to send your password encrypted when possible.
Homepage — Depending on the access point type you are setting up, enter the web
address or the address of the multimedia message centre.
Use access point — Select After confirmation to set the device to ask for confirmation
before the connection using this access point is created, or Automatically to set the
device to connect to the destination using this access point automatically.
Select Options > Advanced settings and from the following:
Network type — Select the internet protocol type to transfer data to and from your
device. The other settings depend on the selected network type.
Phone IP address (for IPv4 only) — Enter the IP address of your device.
DNS addresses — Enter the IP addresses of the primary and secondary DNS servers, if
required by your service provider. To obtain these addresses, contact your internet
service provider.
Proxy server address — Enter the address of the proxy server.
Proxy port number — Enter the port number of the proxy server.
WLAN internet access points
Select Menu > Ctrl. panel > Settings and Connection > Destinations > Access
point, and follow the instructions on the display. Or, open one of the access point
groups, select an access point marked with
, and select Options > Edit.
Use the instructions provided by your service provider to edit the following:
WLAN network name — Select Enter manually or Search for networks. If you select
an existing network, WLAN network mode and WLAN security mode are determined
by the settings of its access point device.
Network status — Define whether the network name is displayed.
WLAN network mode — Select Ad-hoc to create an ad hoc network, and to allow
devices to send and receive data directly; a WLAN access point device is not needed. In
an ad hoc network, all devices must use the same WLAN network name.
WLAN security mode — Select the encryption used: WEP, 802.1x, or WPA/WPA2.
(802.1x and WPA/WPA2 are not available for ad hoc networks.) If you select Open
network, no encryption is used. The WEP, 802.1x, and WPA functions can be used only
if the network supports them.
Use access point — Select After confirmation to set the device to ask for confirmation
before the connection using this access point is created or Automatically to set the
device to connect to the destination using this access point automatically.
Settings 169