User Guide

FPS-10 Flash prommer

FPS-10 interfaces with:

• PC

• Control unit

• Flash adapter

• Smart card

FPS-10 flash prommer features:

• Flash functionality for BB5 and DCT-4 terminals

• Smart Card reader for SX-2 or SX-4

• USB traffic forwarding

• USB to FBUS/Flashbus conversion

• LAN to FBUS/Flashbus and USB conversion

• Vusb output switchable by PC command

FPS-10 sales package includes:

• FPS-10 prommer

• Power Supply with 5 country specific cords

• USB cable

FS-42 Flash adapter

Flash adapter FS-42 is used for phone testing and flashing. FS-42 is

used with the generic flash adapter base and control unit CU-4 or

interface adapter.

When flashing or system testing the phone, the adapter is attached to

replace the phone own battery. All functions (as well as the calibration

voltages, current and the protections for over voltages, over current

and voltage polarity), are performed by CU-4.

MJ-100 Module jig

MJ-100 is meant for component level troubleshooting.

The jig includes an RF interface for GSM, WCDMA and Bluetooth. In

addition, it has the following features:

• Provides mechanical interface with Engine module

• Provides galvanic connection to all needed test pads in module

• Multiplexing between USB and FBUS media, controlled by Vusb

• UI test interface

• MMC interface

• Duplicated SIM connector

• Audio components: IHF, MIC, earpiece

• Connector for control unit

• Access for the system connector

Note: In the picture CU-4 is connected to MJ-100 . CU-4 is not

part of the MJ-100 sales package and has to be ordered

separately.

RM-170; RM-171

Nokia Customer Care Service Tools and Service Concepts

Page 4 –8 COMPANY CONFIDENTIAL Issue 1