User guide

WLAN security mode — Select the
encryption used: WEP, 802.1x, or WPA/
WPA2. (802.1x and WPA/WPA2 are not
available for ad hoc networks.) If you
select Open network, no encryption is
used. The WEP, 802.1x, and WPA
functions can be used only if the
network supports them.
Use access point — Select After
confirmation to set the device to ask
for confirmation before the connection
using this access point is created or
Automatically to set the device to
connect to the destination using this
access point automatically.
To enter the settings for the selected
security mode, select WLAN security
settings.
Advanced WLAN settings
Select Options > Advanced settings
and from the following:
IPv4 settings — Enter the IP address of
your device, the subnet IP address, the
default gateway, and the IP addresses
of the primary and secondary DNS
servers. Contact your internet service
provider for these addresses.
IPv6 settings — Define the type of DNS
address.
Ad-hoc channel (only for ad hoc
networks) — To enter a channel
number (1-11) manually, select User
defined.
Proxy server address — Enter the
address for the proxy server.
Proxy port number — Enter the proxy
port number.
Packet data (GPRS) settings
Select Menu > Ctrl. panel > Settings
and Connection > Packet data.
Your device supports packet data
connections, such as GPRS in the GSM
network. When you are using your
device in GSM and UMTS networks, it is
possible to have multiple data
connections active at the same time;
access points can share a data
connection, and data connections
remain active, for example, during voice
calls.
To define the packet data settings,
select Packet data connection and
When available to register the device
to the packet data network when you
switch the device on in a supported
164 Settings
© 2010 Nokia. All rights reserved.