Nokia Car Kit CK-300 User and Installation Guide 9202247 Issue 1 EN
DECLARATION OF CONFORMITY Hereby, NOKIA CORPORATION, declares that this HF-21W product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. The product is in conformity with the limits defined in Directive 2004/104/EC (amending Directive 72/245/ EEC), Annex I, paragraph 6.5, 6.6, 6.8 and 6.9. A copy of the Declaration of Conformity can be found at http://www.nokia.com/phones/declaration_of_conformity/. 0434 © 2008 Nokia. All rights reserved.
Contents For your safety......................... 4 Quick start................................ 5 Set up........................................................ 5 Input device ............................................ 5 Operation without CarMenu .............. 6 Voice dialing key ................................ 6 Mute key............................................... 6 Mode key .............................................. 6 Call key.................................................. 6 End key.........
For your safety For your safety Read these simple guidelines. Not following them may be dangerous or illegal. Read the complete guide for further information. Your device and its enhancements may contain small parts. Keep them out of reach of small children. SWITCH ON SAFELY Do not switch the device on when wireless phone use is prohibited or when it may cause interference or danger. ROAD SAFETY COMES FIRST Obey all local laws. Always keep your hands free to operate the vehicle while driving.
Quick start Quick start Thank you for choosing the Nokia Car Kit CK-300. With the car kit, you can conveniently make and receive hands-free calls and listen to music stored on your mobile device through your car stereo system. This chapter describes the basic features of the car kit. For details, refer to the respective sections in this guide. ■ Set up 1. Have the car kit installed by a qualified service technician using the original Nokia parts supplied in the sales package.
Quick start ■ Operation without CarMenu You can operate the car kit with or without the CarMenu application. This section describes how you can use the input device when CarMenu is not installed on your mobile device. Voice dialing key Press and hold the voice dialing key to activate voice dialing on a compatible mobile device when no call is in progress. Mute key Press the mute key to switch a call between the car kit and a compatible mobile device.
Quick start Turn the wheel to do the following: • Adjust the volume during a call • Skip to the next or previous track of a playlist, artist, or album when a track is playing or paused ■ Operation with CarMenu If you want to operate the car kit through a user interface optimized for car use, download the CarMenu application from the product page at www.nokia.com or your local Nokia website, and install the application on your compatible mobile device. Also read the CarMenu user guide on the CD-ROM.
Quick start automatically (if the CD-ROM autorun feature is set to on in Windows). Follow the displayed instructions to download the CarMenu installation file from the Nokia website to the PC, and copy the file from the PC to your mobile device or the memory card inserted in it. You can also download the file from the product page at www.nokia.com or your local Nokia website without using the CD-ROM.
Quick start • Switch between the phone and music player mode and Nokia Maps (if running) • Return to the main screen of the current mode Press and hold the mode key to return to the main screen of the phone mode from any mode.
Quick start Press and hold the end key to exit to the main screen of the current mode.
Introduction 1. Introduction With the Nokia Car Kit CK-300, you can conveniently manage handsfree calls and listen to music stored on your compatible mobile device. You can control the car kit using the external input device. If you have a mobile device based on the Series 60 software platform version 3.0 (or higher), you can install the CarMenu application to your mobile device. CarMenu gives you instant access to all your contacts and music tracks saved on your compatible mobile device.
Get started 2. Get started ■ Parts The car kit contains the following parts: 1. Hands-free unit HF-21W 2. Loudspeaker SP-3 (not included in all sales packages) 3. Connectivity cable CA-113CU. The sales package may also contain other connectivity cables. 4. Input device CU-10 5. Microphone MP-2 6.
Get started Switch on If the ignition sense wire is connected, turn on the car ignition. When the car kit is switched on, the CarMenu application installed on your mobile device starts up, and the indicator light of the input device turns on. If the ignition sense wire is not connected, press and hold the Navi wheel. Switch off If the ignition sense wire is connected, turn off the car ignition.
Get started There may be restrictions on using Bluetooth technology in some locations. Check with your local authorities or service provider. Set up a connection with your mobile device For a Bluetooth connection, you need a compatible mobile device that supports Bluetooth wireless technology. When your device is connected to the car kit using Bluetooth wireless technology, you can keep it, for example, in a bag, while using the car kit.
Get started recently. If this fails, the car kit tries to connect to one of the other Bluetooth devices that have been most recently paired with it. The car kit beeps when it connects to the device. Connect the car kit automatically You can set your paired device to allow an automatic connection with the car kit when the car kit is switched on. To do this in Nokia devices, change your paired device settings in the Bluetooth menu.
Use without CarMenu 3. Use without CarMenu ■ Answer a call To answer a call, press . To reject an incoming call, press . ■ End a call To end an active call, press . ■ Make a call To make a call, select the desired contact from the phonebook of your mobile device, or enter a phone number on your mobile device, and press . Call the last dialed number To call the last dialed number, press twice. Voice dialing You can use voice tags that you have saved in your mobile device.
Use without CarMenu ■ Switch a call between car kit and mobile device To switch a call between the car kit and your compatible mobile device, press . ■ Connect a mobile device To connect the car kit to a paired device, press and hold the Navi wheel for about 1 second. ■ Listen to music To start, pause, or resume music playback when the music player of your mobile device is active, press the mode key.
Troubleshooting 4. Troubleshooting ■ Connection issues I cannot connect the car kit to my mobile device through a Bluetooth connection. • Ensure that the car kit is switched on and paired with your device. • Check that the Bluetooth feature is activated on your device. The car kit does not establish a Bluetooth connection to my paired device when I turn on the ignition or switch on the car kit. • Check that the Bluetooth feature is activated on your device.
Troubleshooting The mono output of the car kit is designed for use with a loudspeaker and does not work properly when connected to a car radio. • If the car kit is connected to the supplied loudspeaker, check that the car kit volume is set properly. The car kit does not play sound in stereo. • Check that the car radio is set to receive audio through the stereo input. • Check that you have selected the correct audio source in the car radio. • Check that the car radio volume is set properly.
Troubleshooting ■ Other issues The car kit does not switch on when I turn on the car ignition. Ask the technician who installed the car kit to ensure that the ignition sense wire is properly connected. The battery of the mobile device does not charge when the device is connected to the car kit. Check that all the cables are properly connected.
Installation 5. Installation ■ Safety information Observe the following safety guidelines when installing the car kit. • Only a qualified service technician should install or service the car kit using the approved original Nokia parts supplied in the sales package. Faulty installation or service may be dangerous and may invalidate any warranty which may apply to the car kit.
Installation car kit and any of its components are not installed where you might come in contact with it in the event of an accident or collision. When mounting a mobile holder, ensure that the phone display is clearly visible for the user. • Your service technician or dealer may be able to provide you with information on alternatives for mounting the equipment suitably in your vehicle without requiring drilled holes. • Do not smoke when working on the car.
Installation Cable connection The car kit is supplied with a connectivity cable that has a 2.0-mm (0.08 inch) charging plug and a 3.5-mm (0.14 inch) audio plug. For more information, see “Connectivity cable CA-113CU,” p. 33. Integration with a car stereo system The car kit can be connected to the car stereo system in three different ways. Select the appropriate connection options depending on the components available in the sales package.
Installation Setup option 1 For phone calls, use the ISO system cable CA-139 (if supplied with the car kit), or a cable specific to the car radio, to connect the car kit to the car radio and its speakers. For music, use a cable specific to your car radio to connect the 3.5-mm (0.14 inch) stereo output to the AUX input of the car radio. You can connect the car kit to a loudspeaker with an impedance of at least 2 ohms. The optimal impedance for the car kit is 4 ohms.
Installation 1. Disconnect the two ISO connectors from the car radio for power and loudspeakers, and replace them with the two connectors of the system cable CA-139. Connect the wire labeled "Mute" of the system cable to one of the wires labeled "Mute 1", "Mute 2", or "Mute 3" according to the pinning of the car radio.
Installation connected as they are. Connect the wires of the same colour together. For phone calls, connect the system cable CA-139 to the power output and the loudspeaker output of the hands-free unit. 2. Check the +12-V power pin and the ignition pin of the two ISO connectors coming from the car and the respective pins of the system cable CA-139. If necessary, swap the two wires of the system cable. Connect the system cable to the two open ISO connectors. 3.
Installation Setup option 2 If the car radio has a mobile phone input and an AUX input for music devices, you can connect your mobile device to the speakers of the car radio. 1. Connect the respective wires of the power cable PCU-4 to the car battery and ignition sense (if available). Connect the car radio mute signal (if available) to the car radio. Plug the connector into the hands-free unit. 2.
Installation cable specific to your car radio (this cable is not supplied with the car kit). 3. Connect the stereo music output of the hands-free unit (a standard 3.5-mm stereo connector) to the AUX input of the car radio. Use an appropriate cable specific to your car radio (this cable is not supplied with the car kit). 4. To charge a compatible Nokia mobile device through the car kit, connect one end of the connectivity cable CA-113CU to the handsfree unit and the other end to the 2.0-mm (0.
Installation Setup option 3 You can use the external loudspeaker SP-3 and the power cable PCU-4 as follows (if supplied with the car kit): 1. Connect the respective wires of the power cable PCU-4 to the car battery and ignition sense (if available). Connect the car radio mute signal (if available) to the car radio. Plug the connector into the hands-free unit. 2. For phone calls, connect the loudspeaker output of the hands-free unit to the loudspeaker SP-3. 3.
Installation 4. To charge a compatible Nokia mobile device through the car kit, connect one end of the connectivity cable CA-113CU to the handsfree unit and the other end to the 2.0-mm (0.08 inch) charging connector of the mobile device. To play music from a mobile music player that has a standard 3.5mm (0.14 inch) audio connector, plug the 3.5-mm (0.14 inch) connector of the connectivity cable to the music device.
Installation Hands-free unit HF-21W The hands-free unit has the following connectors. The symbols are printed at the bottom of the unit. —Power —Loudspeaker output for phone calls; for connections, see “Integration with a car stereo system,” p.
Installation 3. Attach the pad with the hooks: peel off the protective sheet from the adhesive side, and attach the pad to the underside of the hands-free unit. 4. Press the hands-free unit firmly onto the loop pad, and check that the hands-free unit stays securely in place. Input device CU-10 The input device should be located so that it is within easy reach of the user.
Installation at least 1 meter (3 feet) from the car kit loudspeaker to avoid audio feedback. Mount the microphone so that it is not exposed to air streams from the vents. Do not place the microphone cable in the heating, ventilation, or air-conditioning system. Use the supplied double-sided adhesive tape to fix the microphone to reduce the amount of background noise of the car that can interfere with your calls.
Installation “Integration with a car stereo system,” p. 23). For details, see the user guide of the car radio. Mobile holder If the mobile device is connected to the car kit with a cable or the car kit is used through the CarMenu application, you need to mount a mobile holder designed for the mobile device that is used with the car kit.
Installation Antenna coupler and external antenna An antenna coupler can be used to connect an external antenna to the car kit. The external antenna improves the reception of the mobile device in a car. For availability, contact your dealer. Note: In order to comply with RF exposure guidelines, install the external antenna so that a minimum distance of 20 centimeters (8 inches) can be maintained between the external antenna and all persons, with external antenna gain not exceeding 3 dBi.
Care and maintenance Care and maintenance Your car kit is a product of superior design and craftmanship and should be treated with care. The suggestions below will help you protect your warranty coverage. • Keep the car kit dry. Precipitation, humidity and all types of liquids or moisture can contain minerals that will corrode electronic circuits. • Do not use or store the car kit in dusty, dirty areas. Its moving parts and electronic components can be damaged. • Do not attempt to open the car kit.
Additional safety information Additional safety information ■ Vehicles RF signals may affect improperly installed or inadequately shielded electronic systems in motor vehicles such as electronic fuel injection systems, electronic antiskid (antilock) braking systems, electronic speed control systems, and air bag systems. For more information, check with the manufacturer or its representative of your vehicle or any equipment that has been added.
