Nokia Bluetooth Headset BH-609 Issue 2.
ENGLISH DECLARATION OF CONFORMITY Hereby, NOKIA CORPORATION declares that this BH-609 product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/phones/ declaration_of_conformity/. © 2010-2011 Nokia. All rights reserved. Nokia, Nokia Connecting People and the Nokia Original Accessories logo are trademarks or registered trademarks of Nokia Corporation.
ENGLISH Introduction With the Nokia Bluetooth Headset BH-609, you can make and answer calls hands-free with your compatible mobile device. The headset is provided with wind noise reduction and noise cancellation that helps you handle calls in noisy environments. Read this user guide carefully before using the headset. Also, read the user guide for the device that you connect to the headset. This product may contain small parts. Keep them out of the reach of small children.
ENGLISH Bluetooth wireless technology Bluetooth wireless technology allows you to connect compatible devices without cables. The headset and the other device do not need to be in line of sight, but they should be within 10 metres (33 feet) of each other. Connections may be subject to interference from obstructions, such as walls, or other electronic devices. The headset is compliant with the Bluetooth Specification 2.1 + EDR supporting the Headset Profile 1.1 and Hands-Free Profile 1.5.
ENGLISH 2. Connect the charger cable to the charger connector. The red indicator light is displayed during charging. Charging the battery fully may take up to 1 hour. Charging the battery with the AC-15 charger for 15 minutes provides up to 2 hours of talk time. 3. When the battery is fully charged, the green indicator light is displayed. Disconnect the charger from the headset, then from the wall outlet.
ENGLISH To switch off, press and hold the multifunction key for about 5 seconds. The headset beeps, and the red indicator light is briefly displayed. If the headset is not connected to a device within about 30 minutes, it switches off automatically. Pair and connect the headset Before using the headset, you must pair and connect it to a compatible device. You can pair the headset with up to eight devices, but you can connect it to a maximum of two devices at a time. 1.
ENGLISH When the headset is connected to at least one device and is ready for use, the blue indicator light flashes slowly. To manually connect the headset to the last or two last used devices, press and hold the multifunction key for about 2 seconds (when no devices are connected), or make the connection in the Bluetooth menu of the desired device. If you have a device connected to the headset and want to connect a second device, make the connection in the Bluetooth menu of the device.
ENGLISH not accidentally attached to the earpad. To use the headset with the earloop, attach the earloop (12). To detach the earloop, gently pull it from the headset. To place the headset on the ear when you use the earloop, push the earloop with your finger (9), and slide the earloop behind your ear (10). Gently push the earpiece against your ear. Point the headset towards your mouth (11). Push or pull the earloop to set its length. Change the volume Slide the volume key up or down.
ENGLISH related icon is displayed on your device (if supported by the device). To switch a call between the headset and a compatible connected device, press and hold the multifunction key for about 2 seconds. To end the active call and make the call on hold active, press the multifunction key. To switch between the active call and the call on hold, press and hold the multifunction key for about 2 seconds.
ENGLISH seconds. The yellow indicator light flashes once. Pair and connect to two devices To pair the headset with two devices, switch on the headset, put it into pairing mode, and pair it with the first device. Switch off the headset, put it into pairing mode, and pair it with the second device. To connect the headset to the two devices, switch the headset off and back on.
ENGLISH the volume key down for about 5 seconds when the headset is connected to a device. The yellow indicator light flashes once. To turn the lights back on, press and hold the multifunction key, and slide and hold the volume key up for about 5 seconds. The green indicator light flashes once.
ENGLISH variant is identified by one of the following: E, X, AR, U, A, C, K, or B. The battery can be charged and discharged hundreds of times, but it will eventually wear out. Talk and standby times are estimates only. Actual times are affected by, for example, device settings, features being used, battery condition, and temperature. If the battery has not been used for a long time, to begin charging, you may need to connect the charger, then disconnect and reconnect it.
ENGLISH Take care of your device Handle your device, charger and accessories with care. The following suggestions help you protect your warranty coverage. • Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that corrode electronic circuits. If your device gets wet, allow it to dry completely. • Do not use or store the device in dusty or dirty areas. Moving parts and electronic components can be damaged. • Do not store the device in high temperatures.
ENGLISH mobile device, www.nokia.mobi/ werecycle. The crossed-out wheeled-bin symbol on your product, battery, literature, or packaging reminds you that all electrical and electronic products, batteries, and accumulators must be taken to separate collection at the end of their working life. This requirement applies in the European Union. Do not dispose of these products as unsorted municipal waste. For more information on the environmental attributes of your device, see www.nokia.com/ecodeclaration.
