Nokia Bluetooth Headset BH-108 4 2 1 3 5 6 7 8 Copyright © 2010 Nokia. All rights reserved.
DECLARATION OF CONFORMITY Hereby, NOKIA CORPORATION declares that this BH-108 product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/ EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/phones/ declaration_of_conformity/. © 2010 Nokia. All rights reserved. Nokia, Nokia Connecting People and the Nokia Original Accessories logo are trademarks or registered trademarks of Nokia Corporation.
software subject to export laws and regulations from the US and other countries. Diversion contrary to law is prohibited. Introduction With the Nokia Bluetooth Headset BH-108, you can make and answer calls hands-free with your compatible mobile device. Read this user guide carefully before using the headset. Also, read the user guide for the device that you connect to the headset. This product may contain small parts. Keep them out of the reach of small children. The surface of this device is nickelfree.
Get started The headset contains the following parts shown on the title page: earpiece (1), indicator light (2), multifunction key (3), earloop (4), charger connector (5), and microphone (6). Before using the headset, you must charge the battery and pair the headset with a compatible device. Parts of the device are magnetic. Metallic materials may be attracted to the device. Do not place credit cards or other magnetic storage media near the device, because information stored on them may be erased.
3. When the battery is fully charged, the green indicator light is displayed. Disconnect the charger from the headset, then from the wall outlet. The fully charged battery has power for up to 5 hours of talk time or up to 120 hours of standby time. To check the battery charge when the headset is not connected to a charger, press the multifunction key when the headset is connected to a mobile device. If the indicator light is green, the charge level is sufficient.
Pair and connect the headset Before using the headset, you must pair and connect it to a compatible device. You can pair the headset with up to eight devices, but you can connect it to only one device at a time. 1. Make sure your mobile device is switched on and the headset is off. 2. If the headset has not been previously paired with a device, switch on the headset. The headset enters pairing mode, and the green indicator light starts to flash quickly.
automatically. To activate this feature in a Nokia device, modify the paired device settings in the Bluetooth menu. Basic use Place the headset on the ear The headset is ready to be used on the right ear. To use the headset on the left ear, attach the earloop to the headset so that it is to the left of the Nokia logo (9). Slide the earloop behind your ear (7), and gently push the earpiece against your ear. Push or pull the earloop to set its length. Point the headset towards your mouth (8).
To switch a call from the headset to a compatible device, press and hold the multifunction key for about 2 seconds, or switch off the headset. To switch the call back to the headset, press and hold the multifunction key for about 2 seconds, or switch on the headset. Clear settings or reset To clear all the settings from the headset, switch off the headset, and press and hold the multifunction key for about 8 seconds. The headset beeps twice, and the red and green indicator lights alternate.
plug variant is identified by one of the following: E, EB, X, AR, U, A, C, K, B, or UB. The battery can be charged and discharged hundreds of times, but it will eventually wear out. Recharge your battery only with Nokia approved chargers designated for this device. If a battery is being used for the first time or if the battery has not been used for a prolonged period, it may be necessary to connect the charger, then disconnect and reconnect it to begin charging the battery.
Taking care of your device Your device is a product of superior design and craftsmanship and should be treated with care. The following suggestions will help you protect your warranty coverage. • Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that will corrode electronic circuits. If your device does get wet, allow it to dry completely. • Do not use or store the device in dusty, dirty areas. Its moving parts and electronic components can be damaged.
uncontrolled waste disposal and promote the recycling of materials. Check product environmental information and how to recycle your Nokia products at www.nokia.com/ werecycle, or nokia.mobi/werecycle. The crossed-out wheeled-bin symbol on your product, battery, literature, or packaging reminds you that all electrical and electronic products, batteries, and accumulators must be taken to separate collection at the end of their working life. This requirement applies in the European Union.
