Certifications 2

Product Name: Prismatic Lithium ion Cell Material Safety Data Sheet
The information and recommendations set forth are made in good faith and believed to be
accurate as of the date of preparation. Tianjin Lishen Battery Co. Ltd. makes no warranty,
expressed or implied, with respect to this information and disclaims all liabilities from
reliance on it
6 of 7
Contaminated packaging
Neither a container nor packing is contaminated during normal use. When internal
materials leaked from a battery contaminates, dispose as industrial wastes subject to
special control.
RCRA Waste Code: Nonregulated
Dispose of according to all federal, state, and local regulations.
1
1
4
4
.
.
T
T
R
R
A
A
N
N
S
S
P
P
O
O
R
R
T
T
A
A
T
T
I
I
O
O
N
N
I
I
N
N
F
F
O
O
R
R
M
M
A
A
T
T
I
I
O
O
N
N
Lishen' BL-5C（1020mAh）Lithium-Ion batteries are considered to be “Rechargeable Lithium Ion
Prismatic Batteries” and meet the requirements of transportation by the International：
Civil Aviation Organization (ICAO) Technical Instructions (2014-2015 Edition), the International
Air Transport Association (IATA) Dangerous Goods Regulation (DGR) 56th Edition 2015
Packing instruction 965 Section IB or II for Lithium Ion battery, the International Maritime
Dangerous Goods (IMDG) Code (2010 Edition) with special provision 188 & 230, US
Harzardous Materials Regulations 49 CFR(Code of Federal Regulations)Sections 173-185
Lithium batteries and cells. the UN Recommendations on the Transport of Dangerous Goods,
Manual of Tests and Criteria 38.3 Lithium batteries, 4th revised edition(UN3480) as
"non-dangerous goods" or "non-hazardous materials". The mentioned batteries are complied with
the special provision, Section I of PI965 to PI967. These lithium batteries can be transported in
nonrestrictive material and as Non-Dangerous Goods as they meet all the requirements in below:
1、Lithium content requirement
1.1 For the bar cells, the lithium content can not overpass 20Wt/h;
1.2 For the batteries, the lithium content can not overpass 100Wt/h;
2 Meet with UN Test Requirement
2.1 All the cell and battery must be verified to meet with all the requirements in Part 3 -38.3 item
(UN38.3 tests) for "Recommendations on the Transport of Dangerous Goods, Manual of Tests and
Criteria" . .
3 Package Requirement
3.1 The cell and battery must be packaged specially and singly, and put into hard outer package to
prevent short-circuit if they do not be assembled in finished equipments (such as mobile
phone,camera,NBPC.and so on)
3.2 The cell quantity is more than 24pcs or the battery quantity is more than 12pcs, they must be
asked to meet with the requirements in blow besides they are assembled in finished equipment.
a Every package must be marked in the content that the packages are loaded in lithium cells or
batteries, also add new lithium iron operation label , also need point out the corrective actions when
the packages are damaged.
b Every batch shipment must be appendixes document which should contain the content that the
packages are loaded in lithium cells or batteries, also need point out the corrective actions when the
packages are damaged.
c Every package must pass 1.2mm fall test in any direction. No damage for the cells and batteries,
no move and touch together, no cells or batteries escape from the package.
d Every package weight can not overpass 10kg if the batteries can not be assembled in finished
equipment.