User Guide

Issue 1 12/04 COMPANY CONFIDENTIAL 45

RAE-6/RA-4

3 - Service Software Instructions Nokia Customer Care

Autotuning

Autotune feature is designed to align product’s RF part easier and faster. By this autotune com-

ponent the product is tuned automatically. The user only needs to press ‘Tune’ and the prod-

uct’s RF is tuned and results are shown to the user. Component controls all the needed RF

equipment (RF generator and TX measuring device) except voltage supplier. The phone

should always be in local mode.

NOTE! Automatic tuning is ALWAYS the primary tuning mode. Manual tuning is not recom-

mended.

The following diagram describes where the autotune component is located in the TSS archi-

tecture:

Figure 2: Autotune component in TSS architecture

Autotune is a pair of two different components. One is User Interface and the other is FunctioN-

al. UI does not contain any functionality. MTI takes care of phone messages.

The Autotune component is located in the Tuning menu:

Figure 3: Autotune menu in Phoenix

Note! This menu is not visible with PKD-1 and PKD-1P dongles.

Figure 4: Autotune menu - RX/TX menu

utotune UI

GPIB Equipment

Autotune FN

MTI

Manual tune FNs GPIB FN

Phone