User Guide

PAMS
Technical Documentation
RAE-3
8. Troubleshooting
Page 8 – 16
Issue 1 06/01
2.1.4 Flash Erasing /Programming Error
Note:
Flash 0 (=D351) erasing area starts 0x00000000
Flash 0 (=D351) erasing area stops 0x003FFFFF
Flash 1 (=D352) erasing area starts 0x01000000
Flash 1 (=D352) erasing area stops 0x013FFFFF
Flash 2 (=D353) erasing area starts 0x02000000
Flash 2 (=D353) erasing area stops 0x023FFFFF
Serial Flash (=D3534 erasing area starts 0x8000000
Serial Flash (=D3534 erasing area stops 0x841FFFF
Change faulty flash D351, D352, D353 or D354
Wintesla informs which memory address the erasing fails. See note which address
corresponds which Flash components.
If the fault information from the prommer is:
a) The erasing status response from the Phone informs about failure.
The Prommer copeies the contents of the response of the Phone into the
preceeding FIASCO_GENERAL_INFO_IND message.
b) The Phone has generated a NAK signal during data block transfer.
c) The programming status response from the Phone informs about failure.
The Prommer copies the contents of the response of the Phone into the
preceeding FIASCO_GENERAL_INFO_IND message.
FLASH programming does not work
YES
YES
Erasing/Programming fails
Figure 8.