User Guide

PAMS
Technical Documentation
RAE-3
8. Troubleshooting
Page 8 – 115
Issue 1 06/01
5.2 PCN Receiver
General Instructions for troubleshooting
Connect the phone to a PC with a DAU–9P cable
Start Wintesla–Service–Software and
Select P
roduct Alt+p
Open…
RAE–3
Select: P
roduct Alt+p
B
and b
P
CN p
Select: Te
sting Alt+e
R
F Controls r
R
X Continuous Alt+r
Co
nt. Mode Ch:700 Alt+o, 700
AGC Absolute: 8. . . .
Multislot on Alt+u, if on remove checkmark
The set–up should now look like this (Figure 119):
Figure 119.
Apply a 1842.867 MHz (channel 700 + 67.710kHz offset) –95dBm signal to the
RF–connector (remember to compensate for cable attenuation).
Measuring with an oscilloscope on “Hagar RXI” or “Hagar RXQ” this picture
should be seen on a working PCN receiver: