PAMS Technical Documentation RAE–2 Series PDA Phone Chapter 09 Mechanical Parts and Disassembly Original 02/99 Copyright 1999 Nokia Mobile Phones. All rights reserved.
PAMS RAE–2 Mechanical Parts Technical Documentation AMENDMENT RECORD SHEET Amendment Number Date 02/99 Page – 2 Inserted By Comments Original Original 02/99
PAMS Technical Documentation RAE–2 Mechanical Parts CONTENTS Page No Exploded Diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . List of Mechanic Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . LCD / UI Module Disassembly . . . . . . . . . . . . . . . . . . . . . . . . . . . –4 –5 –6 System Module Disassembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PAMS RAE–2 Mechanical Parts Technical Documentation RAE–2 Exploded diagram below 1 2 3 5 4 7 6 8 9 10 12 11 14 13 16 15 17 18 19 21 20 24 22 26 23 28 30 32 34 Page – 4 25 27 33 31 29 Original 02/99
PAMS RAE–2 Mechanical Parts Technical Documentation List of Mechanic Parts Item Code Description Specifications / Ratings 1 9456203 Front cover with lens 2 6190033 Screw M1,6x5 6 pcs 3 9790326 Phone keypad 4 0201097 Phone UI PCB 5 4850063 Phone LCD 6 4850801 PDA Display ELbacklight 7 9855044 Hingle flex 8 4850049 PDA LCD 9 9780234 Coaxial cable 10 9460251 Flex cover 11 9460248 Hinge end 12A 9460249 Latch 12B 6402165 Spring 13 0660183 Antenna 14 9790330 Func
PAMS RAE–2 Mechanical Parts Technical Documentation LCD / UI Module Disassembly 1. Remove battery. 2. Remove cover label (A) and screw (B). 3. Gently lift off front cover starting from both sides in the bottom end of the phone or by pulling the top end of front cover. 4. Remove phone keymat. 5. Remove 5 screws (C) and 2 washers (D). 6. Disconnect flex connectors by releasing connector clips. Connectors will be opened by lifting the clip up. 7. Unplug the coaxial cable. 8.
PAMS RAE–2 Mechanical Parts Technical Documentation Figure 1. Figure1. Correct way to assemble the coaxial cable in the lid part.
PAMS RAE–2 Mechanical Parts Technical Documentation System Module Disassembly Page – 8 1. Remove battery. 2. Remove four plugs (34) and six screws (31). 3. Remove audio cover, audio holder and back cover, be careful not to touch sensitive parts of earpiece. 4. Unplug the coaxial cable. 5. Remove CMT PCB, system connector and IR window. CMT PCB might be very tightly connected, use necessary force to remove it. 6. Open chassis. Disconnect flex connector by releasing connector clip.
PAMS RAE–2 Mechanical Parts Technical Documentation Figure 2. Figure 2. Correct way to assemble coaxial cable between the guiding pins. Figure 3. Figure 3. Correct way to assemble coaxial cable on CMT PCB.
PAMS RAE–2 Mechanical Parts Technical Documentation Figure 4. Correct way to assemble coaxial cable under hinge flex cover.
