User Guide

Service software installation

Phoenix installation steps in brief

Phoenix is the DCT-4 generation service software for reprogramming, testing and tuning the phone.

To install Phoenix, you need to:

• Connect a DK2 Dongle or FLS-4S POS Flash Device

• Install the Phoenix Service SW

• Install the Data Package for Phoenix

• Configure users

• Manage connection settings (depends on the tools you are using)

Phoenix is now ready for FLS-4S Point Of Sales Flash Device use.

If you use FPS-8:

• Update FPS-8 SW

• Activate FPS-8

• Update JBV-1 Docking Station SW (only when needed)

Phoenix is now ready to be used with FPS-8 flash prommer and other tools as well.

The Phoenix Service Software installation contains:

• Service software support for all phone models included in the package

• Flash update package files for FPS-8* and FLS-4S programming devices

• All needed drivers for:

• DK2 dongle

• FLS-4S point of sales flash device

• USB devices

Note: Separate installation packages for flash update files and drivers are also available, but it is not

necessary to use them unless updates appear between Phoenix Service SW releases. If separate update

packages are used, they should be used after Phoenix and data packages have been installed.

Supported operating systems

• Windows 2000 and XP.

Hardware requirements for using Phoenix

• Minimum: Processor 300 MHz, RAM memory 64 MB, disk space 100 MB.

• Recommended for Windows 2000: Processor 700 MHz, RAM memory 256 MB, disk space 150 MB.

Installing Phoenix

Before you begin

• Check that a Dongle is attached to the parallel port of your computer.

• Download the installation package (for example, phoenix_service_sw_a15_2004_24_7_55.exe) to your

computer (in C:\TEMP, for instance).

• Close all other programs.

• Run the application file (for example, phoenix_service_sw_a15_2004_24_7_55.exe) and follow the instructions

on the screen.

• Administrator rights may be required to be able to install Phoenix depending on the operating system.

• If uninstalling or rebooting is needed at any point, you will be prompted by the Install Shield program.

RM-13/33

Phoenix Service Software Instructions Nokia Customer Care

9240218 (Issue 1) Company Confidential Page 3–5