User Guide

Min Typ Max

PL0 coefficient 0.45 0.482 0.7

PL11 coefficient 0.218

PL15 coefficient 0.12 0.184 0.3

GSM1900 EDGE on

PL2 coefficient 0.35 0.377 0.6

PL11 coefficient 0.23

PL15 coefficient 0.12 0.193 0.3

If the values are within the limits, check that the Save to Phone Permanent Memory check box is checked

and click Stop.

10. Set Edge mode on and start tuning again. Change video averaging to 50.

11. Tune EDGE power levels to the corresponding target power levels.

All power must be tuned. Check the coefficients against the RF tuning limits table presented in Step 9.

12. When the tuning is completed, click Stop .

Next action

Repeat steps 4 to 9 for all bands. On those bands only power levels 0, 11 and 15 need to be tuned.

Tuning TX/IQ

Context

The tuning must be carried out in all three bands. In addition to Phoenix, a spectrum analyzer (SA) is needed.

Steps

1. Connect the spectrum analyzer (SA) to the RF connector of the module jig. The settings of the SA will depend

on the band to be tuned. The following table summarizes the settings for each of the three bands.

Table 14 Spectrum analyzer settings

GSM900 GSM1800 GSM1900

Center frequency 897.4MHz 1747.8MHz 1880MHz

Frequency span 300kHz 300kHz 300kHz

Resolution Bandwidth 3kHz 3kHz 3kHz

Video Bandwidth 3kHz 3kHz 3kHz

Sweep Time 3 sec 3 sec 3 sec

Trace Type Clear/Write Clear/Write Clear/Write

RM-13/33

Nokia Customer Care RF Troubleshooting and Tuning

Page 7–18 Company Confidential 9240218 (Issue 1)