User Guide

CCS Technical Documentation Service Tools
RH-10
Issue 1 09/2002 Nokia Corporation Confidential Page 9
PKD-1 SW Security
Device
0750018 SW Security Device is a piece of
hardware enabling the use of the
service software when connected
to the LPT (parallel port) of the
PC. A dongle is required for use
of the service software. A printer
or any such device can be con-
nected to the PC through the
dongle, if needed.
Cautions: Make sure that you
have switched off the PC and the
printer before making connec-
tions. Do not connect the PKD-1
to the serial port. You may dam-
age your PKD-1.
JBU-11 Docking Sta-
tion
0775294 The Docking Station and RF
Adapter RC1 are needed for
Mbus, Fbus, and RF connections.
The Docking Station also may be
used without RC1 if RF output is
not desired. The Docking Station
may be powered by the FPS-8
setup or by an external power
supply.
Note: Toggle the DC power supply
switch to correct mode before
applying power.
RC1 RF Adapter 0775296 Used with the Docking Station
JBU-11, above. The RC1 uses the
GAC-5 for RF interface.
XRS-5 RF Connector 0730228 XRS-5 (shown at left in drawing)
is used for readings, in conjunc-
tion with the BBS-10 service
battery.
Note: Use with protection grom-
met, pictured at lower right.
GAC-5 RF Connector 0770473 GAC-5 is used with JBU-11/RC1
and MJS-59 to make RF connec-
tions. This connector is included
with both tools; however, it is
available separately as a user-
replaceable part in the event of
damage. The connector and both
jigs are designed to accept a
micro in-line attenautor. This
permits attenuation as close to
the source RF as possible.