User Guide

NSD-5
7. Service Software Instructions PAMS Technical Documentation
Page 6 Nokia Corporation Issue 1 05/02
The software controls the phone via Flash Loading Adapter (FLA-38) and RS-232/MBUS
Interface (DAU-2T) with a D25-D9 connector connected to the serial port of the PC.
Attach the protection key PKD-1 to the parallel port 1 (25-pin female D-connector) of
the PC. When connecting the PKD-1 to the parallel port, be sure that you insert the com-
puter side of the PKD-1 to the PC (male side). If you use a printer on parallel port 1,
install the PKD-1 between the PC and your printer cable.
WinTesla Software Installation
Parts Required
From the PAMS web site, enter the following selections, starting from the home page:
Software>Product Specific Service Software>CDMA>Wintesla DCT3 CDMA Service
Software (NSD-5)
Note: A floppy disk version also is available from the PAMS web site: WT264.diskettes.zip (complete
CDMA Wintesla version) and NSD_W264.diskettes.zip (CDMA dll version). These versions, when
unzipped, will create files sized to be placed on multiple floppy disks.
Procedure
Installation steps for new WinTesla DLL
Note: Previous WinTesla installation required.
1 Check the WinTesla Core SW version on the Help menu. Select About from the
drop-down menu.
2 Make sure that you have one of the following WinTesla core SW versions 6.43. If
you don’t have it installed, read Note 1 which follows below.
3 Download the self-extracting file NSD_W264.EXE to your own workstation. Dou-
ble-click on the file to extract the actual files and to auto-load the program.
4 Note that it is not necessary to restart your computer.
5 Customer-specific software files are not included with the WinTesla software
packages. To get the necessary customer-specific files, download one or more of
the flash software packages. For specific instructions, refer to the specific Tech-
nical Bulletin releasing flash software for a particular customer / product to be
supported. Double-clicking on these packages will self-install the Config file,
flash file, PRLs, and PRIs into the appropriate locations.
Note 1: If you are installing WinTesla for the first time in your PC, the complete WinTesla Installation
Pack SW for CDMA phones is required. The complete pack includes all other drivers and core mod-
ules that are needed to run WinTesla with NSD-5 phones. This software is available from the PAMS
web page or may be ordered (Product Code 0081309). For more detailed instructions, refer to the Win-
Tesla User Guide for CDMA using FLS-2D Dongle, document number SGY00139-EN.