Manualshelf

User Guide

ManualsBrandsNokia ManualsCell Phone8270
12345678910
PAMS Technical Documentation 7. Service Software Instructions
NSD-5
Issue 1 05/02 Nokia Corporation Page 5
WinTesla / Diego User’s Guides
General
The name TESLA, when used by Nokia, is an acronym for TEst and Service Locals Applica-
tion. Tesla for Windows (i.e. WinTesla) is a software package designed to operate in the
Microsoft Windows environment. The software package is made of two modules, the
WinTesla core module, with drivers and a service software module DLL, and a service
software module. The WinTesla module is similar to an operating system for various ser-
vice modules. In this way many Nokia products can be serviced using one common soft-
ware package.
NOTE: The WinTesla core module MUST be installed for ”any” service module to run.
Service Software
Due to the modular design of Service Software, various generations of Nokia products
can be serviced while sharing a similar user interface. The common user interface is
explained in the first part of this section, followed by specific module information.
The software can be used to control the phone by entering commands via PC/AT/NT, run-
ning Microsoft Windows 95, 98, or NT. If you are not familiar with the Windows inter-
face, consult the Microsoft Windows User Guide for more information.
Equipment Requirements
Computer: PC Pentium, 100MHz minimum, or compatible. At least one unused serial
port, COM1 or COM2, one parallel port (LPT1), 5MB hard disk space, and 16MB RAM.
Display: Any supported by MS Windows (Windows 95, 98, or NT).
Operating System: running MS Windows 95, 98, or NT.
WinTesla Application Software (Product Code 8405043).
Diego Application Software (Product Code 8405139).
Software Protection Key (PKD-1) (Product Code 0750018) or FLS-2D (Product Code
0081310).
Phone-specific Service Software Module (Product Code - see phone-specific informa-
tion).
Mechanical Connections
Caution: Make sure that you have switched off the PC and the printer before making
connections.
Caution: Do not connect the PKD-1 key to the serial port. You may damage your PKD-1
key.