User Guide

NSD-5
7. Service Software Instructions PAMS Technical Documentation
Page 18 Nokia Corporation Issue 1 05/02
2. Select Flash image (or let WinTesla decide for you)
You can select a flash file by clicking the Browse button. Or, you can leave the file name
field empty and let WinTesla decide which flash image to use. Please note this requires a
phone specific .cfg file be put into .../misc directory.
3. Flash
FAQs:
How to select flashing device?
Go to Configure Menu/FLS–X and check Use Fls–x for POS, otherwise uncheck it.
If the phone is totally dead, go to the Advanced Options and select Flash Dead Phone.
Then flash the phone.
What if error occurs during the user data saving?
No damage is done to your phone at this stage. So go ahead and flash it again.
What if error occurs during flashing?
If the phone is dead after dead phone flash, you must re-tune the phone.
What if error occurs after EEPROM resetting?
This means that the EEPROM data is damaged. But if you selected Yes to Save User Data,
all the user data is saved on the disk. Check your phone. If the phone is dead, select Flash
Dead Phone, then flash it to get the phone to work. Restore all the data without flash. To
do this, go to advanced options, and select Restore Data Only.