User Guide

NSM–3
Service Software Instructions
PAMS Technical Documentation
Page 76
Issue 1 12/1999
 Nokia Mobile Phones Ltd.
fields are not valid, then check box is disabled. Checkbox state
is read from flash pack ini–file, from entry EraseDefinedArea.
Low limit edit box (read only):
Hexadecimal value defining low erase limit, value should be
plain hexadecimal without any prefix. Field value is read from
flash pack ini–file, from entry LowEraseLimit.
High limit edit box (read only):
Hexadecimal value defining high erase limit, value should be
plain hexadecimal without any prefix. Field value is read from
flash pack ini–file, from entry HighEraseLimit.
Force D
ownload check box (ALT+D):
Forces downloading of selected PPM file to a prommer even, if
it already exists there. Can be used to replace a corrupted file
in a prommer with a proper one.
ROM Version Group:
ROM Version edit box:
Shows rom version of flashed phone.
Check button (Alt+A):
Checks connected phone, reads MCU SW and ROM version
from the phone and loads market areas. If application cannot
detect ROM version, user is shown ROM Version selection
dialog. If application cannot detect phone type, user is shown
Phone Type Selection dialog.
LPT Port list box (ALT+L):
User can select parallel port to be used when flashed.
During flashing status dialog is showed. After phone is flashed current
time in PC is set to phone and user is asked to check that the time is cor-
rect. If flashing succeeded “Flashing completed!” message is shown to
user, if flashing failed “Flashing failed” message is shown instead.
After flashing phone several self–test are checked or run. If some of those
fail, then Flash Id, factory sets or user settings are not written to phone.
For example if SW Version fails, then MCU SW version does not match
phone HW and user should flash MCU SW and PPM for correct ROM ver-
sion.
Phone Type Selection dialog