Cell Phone User Manual

Settings

Note: The speeds above represent the maximum speed at which your connection

will operate. During the connection, the operating speed may be less, depending

on network conditions.

Options→ Advanced settings

• Phone IP address - The IP address of your phone.

Glossary: DNS -

Domain Name Service. An

Internet service that

translates domain names

such as www.nokia.com

into IP addresses like

192.100.124.195.

• Primary name server: - The IP address of the primary DNS server.

• Second. name server: - The IP address of the secondary DNS server.

Note: If you need to enter the Phone IP address, Primary name server, or Second.

name server:, contact your Internet service provider to obtain these addresses.

The following settings are shown if you have selected data call and high speed data as the

connection type:

• Use callback - This option allows a server to call you back once you have made the initial

call, so you have a connection without paying for the call. Contact your service provider

to subscribe to this service.

Note: Charges may apply for certain types of received calls, such as roaming and

high speed data calls. Contact your GSM network operator for more information.

Note: The phone expects the callback call to use the same data call settings that

were used in the callback-requesting call. The network must support that type

of call in both directions, to and from the phone.

Glossary: PPP

(Point-to-Point Protocol)

- a common networking

software protocol that

enables any computer

with a modem and a

phone line to connect

directly to the Internet.

• Callback type - The options are Use server no. / Use other no.. Ask your service provider for

the correct setting to use; it will depend on the service provider’s configuration.

• Callback number - Key in your phone’s data phone number which the dial back server

uses. Usually, this number is the data call phone number of your phone.

• Use PPP compression - When set to Yes, this option speeds up the data transfer, if

supported by the remote PPP server. If you have problems with establishing a

connection, try setting this to No. Contact your service provider for guidance.

• Use login script - The options are Yes / No.

• Login script - Insert the login script.