User Guide

NMM-3 Company Confidential
7 - System Module & UI CCS Technical Documentation
Page 7-26 Copyright  2003 Nokia Corporation Issue 1 (11/2003)
Company Confidential
NMM-3 Test interfaces
The following interfaces available:
• 9 way test access pads including Fbus, flashing, DAI if needed (Mbus pin) and STI.
• 3-way battery interface repeated under the battery used for production test.
• Service software will use Phoenix SW via USB on Pop-Port connector or FBUS via
the FLA-45 service battery or JBV-1 docking station.
Baseband General Specification
Absolute Maximum Ratings
DC Characteristics
Regulators and Supply Voltage Ranges
Battery Voltage Range
BB Regulators
Pin Control System control
enable 1=On UEMRSTX enabled at UEME delay0
0=0ff
mode 1=ON SLEEPX Rises when PURX=1, then under deep sleep control.
Signal Limit
Battery Voltage (Idle) -0.3 - +5.5V
Battery Voltage (Call) 4.8V MAX
Charger Input Voltage -0.3V - +16V
Signal Min Nom Max
VBAT 3.1V 3.7V 4.2V (Charging high limit target voltage)
Signal Min Nom Max Output Current
VANA 2.70V 2.78V 2.86V I
max
= 80mA
VFLASH1 2.70V 2.78V 2.86V I
max
= 70mA
I
sleep
= 1.5mA
VAUX2 2.70V 2.78V 2.86V I
max
= 70mA
I
sleep
= 0.5mA
VSIM 1.745V
2.91V
1.8V
3.0V
1.855V
3.09V
I
max
= 25mA
I
sleep
= 0.5mA
VIO 1.72V 1.8V 1.88V I
max
= 150mA
I
sleep
= 0.5mA
VCORE 1.71V 1.8V 1.89V I
max
= 200mA