User Guide

ManualsBrandsNokia ManualsCell Phone7280

Nokia Customer Care

5 - Disassembly Instructions

5-Disassembly and Reassembly

Instructions

Summary of content (14 pages)

PAGE 3
RM-14 Disassembly and Reassembly Instructions Nokia Customer Care Table of Contents Page No Disassembly Instructions................................................................................... 5 Display Exchange Instructions ........................................................................ 11 Reassembly Instructions.................................................................................. 13 ISSUE 1 11/04 COMPANY CONFIDENTIAL Copyright © 2004 Nokia. All Rights Reserved.
PAGE 5
RM-14 Disassembly and Reassembly Instructions Nokia Customer Care Disassembly Instructions 1.) Use the SIM tray release tool to open the SIM Holder. 2.) Open the Slide Cover. 3.) Use the SRT-6 as a lever to remove the Slide Cover. 4.) First shift the Slide Cover as far as it will go and then remove it from its guide. 5.) Place SRT-6 between the A-Cover and B-Cover and shift it along the edge. Use always a new ACover and a new B-Cover when reassembling. 6.) Open the other snaps.
PAGE 6
RM-14 Nokia Customer Care Disassembly and Reassembly Instructions 7.) Separate the both covers from each other. 8.) The Keymat drops out when turning the A-Cover. 9.) Lift the modules from the B-Cover by using SRT6. 10.) Protect the LCD Cell with a film. 11.) Use a slotted screwdriver to lift the Battery Lock. 12.) Do the same on the other side. 13.) Remove the Locking Ring. 14.) Remove the Battery. 6 COMPANY CONFIDENTIAL Copyright © 2004 Nokia. All Rights Reserved.
PAGE 7
RM-14 Disassembly and Reassembly Instructions Nokia Customer Care 15.) Unlock the UI Module by turning it a bit. 16.) Now, lift the UI-Module as shown in the picture. Take care not to damage the Rotator Flex. 17.) Be carefully when removing the Rotator Flex. Note the right position of the contacts when assembling. 18.) Use a slotted screwdriver to open the C-Cover clips. 19.) The same procedure on the other side. 20.) Move the C-Cover Assy a bit to the left as shown in the picture. 21.
PAGE 8
RM-14 Nokia Customer Care Disassembly and Reassembly Instructions 23.) Release the Engine Module by bending slightly both plastic battery guides of the D-Cover. 24.) Remove the Engine Module from the D-Cover. For assembly only! For assembly only! Put the Engine Module on the Pogo pins of the DCover. Place the Engine Module in the clamps of the DCover by pressing it slightly. 25.) Put the Engine Module in to the soldering jig. 26.) Use the SRT-10 to release the VGA Camera.
PAGE 9
RM-14 Disassembly and Reassembly Instructions 27.) Remove the VGA Camera by using the corrugated tweezers. Nokia Customer Care 28.) Release the snap of Earpiece Connector by using the slotted screwdriver. . 29.) Remove the Earpiece Connector ISSUE 1 11/04 COMPANY CONFIDENTIAL Copyright © 2004 Nokia. All Rights Reserved.
PAGE 10
RM-14 Nokia Customer Care Disassembly and Reassembly Instructions For assembly only! For assembly only! Place the Earpiece Connector in its guidance. Lock the snap of the Earpiece Connector by using a slotted screwdriver. Take care of the Flex Assy. 30.) Remove the Earpiece. 10 COMPANY CONFIDENTIAL Copyright © 2004 Nokia. All Rights Reserved.
PAGE 11
RM-14 Disassembly and Reassembly Instructions Nokia Customer Care Display Exchange Instructions 1.) Push out the LCD Cell carefully by using a clean cloth. 2.) Remove the remaining adhesive of Display Conductive Tape. 3.) Be carefully when removing the remaining adhesive from the LCD CELL. Do not scratch the its surface. 4.) Clean the LCD CELL with a clean micro fibre cloth carefully. 5.) Fit the Display Conductive Tape to the C-Cover. Note the right position. 6.) Remove the protective film.
PAGE 13
RM-14 Disassembly and Reassembly Instructions Nokia Customer Care Reassembly Instructions Reassembly should be done in reversed order to disassembly. ISSUE 1 11/04 COMPANY CONFIDENTIAL Copyright © 2004 Nokia. All Rights Reserved.