User Guide

Table Of Contents

RH-23 Company confidential

CCS Technical Documentation

MJ-17 Module Test Jig

Module Test Jig MJ-17 is designed for 1AQ and 1BF (upper block) testing. It can be used

for flashing, system testing and troubleshooting.

MJ-17 take in use instructions

UI board assy has been semi fixed in jig.

Upper block flex assy with needed spare parts and without the earpiece has to be assem-

bled to the jig and can be changed when needed.

Engine pwb is just pressed in place. Please ensure the flex pwb connector and the RF

connector are properly connected. If problems occur with RF connection between an RF

connector and an RF probe, you can help it by loosening an RF probe from the bottom of

the jig and help connecting by hand.

Instructions to assemble the upper block parts to the module jig

The phone spare parts needed in the module jig to have the upper block functionality in

the jig:

1 Upper block flex assy (0263440). NOTE: Earpiece has to be removed before

assembling upper block flex assy to the jig!!

2 LCD module 128X128 (4850347)

3 LCD module B/W 96X36 (4850361)

4 VGA camera module (4858023)

5 Shield small VGA camera (9511279)

Instructions to assemble the parts to the jig:

1 Remove earpiece from Upper block flex assy

2 Assemble parts 2-4 (on the list above) to upper block flex assy

3 Loosen upper block locking screws of the module jig

4 Insert upper block flex assy to the jig and ensure connector on flex pwb is con-

nected

5 Tighten screws to keep upper block flex assy in place