User Guide

RH-23

CCS Technical Documentation

Service Tool Concept for RF Tuning Operations

NOTE! RF tunings need to be done ONLY if any RF block component is replaced.

• All RF tuning operations must be carried out in the MJ-17 Module Jig!

• Power to MJ-17 must be supplied from an external DC power supply, not

FPS-

8 prommer

• MJ-17 input voltages:

Maximum + 5 VDC

Nominal input for RF tunings is +4.2 V DC

Minimum +3V DC

• Remember the cable attenuation when setting required RF levels

Figure 1: RF tuning setup

Item: Type: Description: Code:

1 MJ-17 Module jig 0770586

2 PCS-1 DC power cable 0730012

3 XRF-1 RF antenna cable 0730085

4 DAU-9S Service Mbus cable 0730108

5 PKD-1 Software protection key 0750018

6SW