User Guide

PAMS Technical Documentation Service Software
NSB-5
Issue 1 03/01 Nokia Mobile Phones Ltd. Page 7
WinTesla NSB-5 Service Software
The service software test functions send test and measurement messages from PC to
mobile station (MS). The results of the test and measurement messages are shown on the
PC display.
The WinTesla service software requires a DESKey software protection device to be con-
nected to the PC’s parallel port. The PKD-1 and and Point of Sale POS Flash device
(FLD-2D) fulfill this requirement. The POS flash device (TDF-4) Prommer is required for
flashing SW. Having a PKD-1 installed on the printer’s parallel port allows access to the
tuning functions for testing and tuning of the NSB-5 MS.
NOTE: If this software is to be run on laptops, the power-saving feature MUST be
switched off. If this is not switched off, you need to re-establish connection to the phone
after power-saving has been active.
WARNING: Do not install the FLS-2D on the parallel port with the PC powered up.
Hardware Requirements for Windows 3.1x
The recommended minimum hardware standard to run WinTesla service software is any
computer that is an Intel 80386 33 MHz or greater with at least 4MB of memory and a
VGA-type display (640 x 480). This assumes that only the WinTesla service software is
active (i.e., other Windows packages are not running in the background).
Hardware Requirements for Windows 95, 98, and NT
The recommended minimum hardware standard to run WinTesla service software is a PC
with a Pentium processor with available memory of 8MB. The PC also must meet the
hardware requirements recommended by Microsoft.
Software Environment of the Support Modules
The WinTesla service software user interface (UI) is intended for the following environ-
ments: Microsoft Windows 3.1x and Windows 95 running in enhanced mode;
Windows 98; and Microsoft NT 3.51 or later. Windows 2000 is not supported. As a Win-
dows application, the user interfaces with the process via selections made from menus,
text entry, pushbuttons, and shortcut keys. Selections are performed by using the key-
board and/or mouse inputs. The status bar displayed at the bottom of the main menu
window contains information about current actions.
Required Servicing Equipment
1. Computer: At least IBM 80386 or compatible with one unused serial port (COM1 or
COM2)*, one parallel port (LPT1), 20Meg of free hard disk, 3.5-inch floppy disk, and 4Meg
of RAM.
2. Operating System: Win 3.1 or later.
3. Display: Minimum monochrome graphic display with 640 x 480 resolution
4. One of the following protection keys: