User Guide

NSB-5
Service Software PAMS Technical Documentation
Page 60 Nokia Mobile Phones Ltd. Issue 1 03/01
Get Defaults button (ALT+G):
Gets default Call Simulation values as current values.
Noise Sensitivity... command
A GSM/Signal generator and an antenna cable is needed for this test. The active band
must be set to the GSM band.
Activation Status Bar Text
Alt, E, N Initializing local mode...;
Noise Sensitivity; Set test on...;
Command is used for noise sensitivity measurement.
The next automatic selections are made when this tuning function is activated:
-Active unit = RX
-Operation mode = Burst
-AGC value = 81 dB
Before the function opens, the “Noise Sensitivity” appears:
Figure 29: Noise Sensitivity - Set High Reference Level Dialog
Then the application opens the “Noise Sensitivity” dialog box.
Figure 30: Noise Sensitivity Measurements & Ranges Panel