User Guide

PAMS Technical Documentation Service Software
NSB-5
Issue 1 03/01 Nokia Mobile Phones Ltd. Page 53
executed state after the power-up routines).
Run button (ALT+R):
User can select desired test from list and select the Run button. When user selects test to
be run, the text RUNNING... is shown in test state field and test is run. When results are
received, the test state field is updated according to the result.
If no response was received in the defined time, an “Error Message” dialog box will be
shown and the test state is changed to No response. Phone is set to local mode if it is not
already there.
Run All button (ALT+A):
User can run all listed tests. The text RUNNING... is shown in test state field and test is
run. When results are received, the test state field is updated according to the result.
When state field is updated, application moves to next test and repeats previous cycle.
Phone is set to local mode if it is not already there.
Supported Self Tests
The following tests are available:
1 MCU ROM Checksum................
2 MCU RAM Interface...............
3 MCU RAM Component...............
4 MCU EEPROM Interface............
5 MCU EEPROM Component............
6 RTC Battery.....................
7 CCONT Interface.................
8 A/D Converter...................
9 SW Reset........................
A Power Off.......................
B Security Data...................
C EEPROM Tune Checksum............
D PPM Checksum....................
E MCU Download DSP................
F DSP Alive.......................
G COBBA Serial.......................
H COBBA Parallel.....................
I EEPROM Sec Checksum................
J PPM Validity..................................
K Warranty State..............................
ADC Readings... command
Activation Status Bar Text
Alt, E,A ADC Readings; Set test on...
ADC Readings; Reading from ME....
Command is used to read and show A/D values from phone.