User Guide

NSB-5
Service Software PAMS Technical Documentation
Page 52 Nokia Mobile Phones Ltd. Issue 1 03/01
to the user within the “MCU Self tests” dialog box.
Figure 23: MCU Self tests Dialog
Dialog mode: modal
The “MCU Selftests” dialog box has following items:
Tests list box (ALT+T):
The field ”(p)” in the screen example means that the test is also run in power up. The field
“(/s)” means that this test is the selectable one.
Test states are updated according to results received from the phone. Possible test states
will be one of the following:
Passed
Failed
No response
Not executed
Not valid
RUNNING....
NOTE: The power-off test has no values, because if the test has been passed, power has
been turned off. If power-off test fails, a special error message window is shown. If no
response is received to power off test message in a few seconds, the user is informed by
a special info window, where user is asked to turn the power on and then press the
Return key.
NOTE: The power-off test (if passed) turns power off and power should be reconnected
by using the phone’s keypad after the successful test. After the power has been con-
nected to phone, the normal start-up routines are made and the self-test results are
shown in the “MCU Self Tests” menu (i.e., all other than power-up self-tests are in Not