User Guide

PAMS Technical Documentation Service Software
NSB-5
Issue 1 03/01 Nokia Mobile Phones Ltd. Page 49
selected. Possible options are:
-Random pattern
-Continuous zeroes
-Continuous ones
The TX Data Type is greyed when the active unit is RX.
TX Power Level edit box (ALT+X):
With this value, it is possible to change the transmission power. The user can give the
needed power value or select the test value, which is tuned with TX power tuning func-
tion. The test value is found at the end of the list.
TX Power has a value OFF and is disabled (greyed) when active unit is RX. When the TX
power is tuned with test value (smallest value) the TX Power has the value TEST.
Channel edit box (ALT+N):
Here the user can enter the channel number that is used for both transmission and
receiving. The frequency of the selected channel is shown after selection. The channel
edit box is disabled (greyed) when the operation mode is continuous.
Monitoring Channel edit box (ALT+M):
This field selects neighbor monitoring channel. The frequency of the selected channel is
shown after selection. The monitoring channel edit box is disabled (greyed) when the
operation mode is burst.
Continuous Mode Channel edit box (ALT+O):
To this edit box, the user can type continuous mode channel, which may have all channel
numbers. The continuous mode channel edit box is disabled (greyed) when the operation
mode is burst.
The used frequency depends on the Active Unit. If Active Unit is RX, then RX frequency is
used, else TX frequency is used. The frequency of the selected channel is shown after
selection.
AGC Absolute edit box (ALT+L):
This selection allows user to edit AGC absolute value (value from A/D converter).
When AGC Absolute value is changed, the AGC dB value will be calculated, depending on
the AGC Absolute value. The AGC Absolute edit box is disabled (greyed) when the opera-
tion mode is burst.
Front End On chec box: (ALT+E)
This selection allows the user to change whether the Front End amplifier is On or Off.
The Front End On check box is disabled (greyed) when the operation mode is burst.
AGC edit box (ALT+G):
This selection allows the user to edit AGC value in dB.