User Guide

NSB-5
Service Software PAMS Technical Documentation
Page 48 Nokia Mobile Phones Ltd. Issue 1 03/01
RX radio button (ALT+R):
When RX is selected, the next functions are made:
Data transmission is deactivated
-TX power is deactivated
-Rf operation mode is continuous,
-AGC is controlled
-RX continuous mode channel is activated
-RF Information window is updated
The RX value is always given as default.
NOTE: Function is activated immediately; the Apply button is not needed.
TX radio button (ALT+T):
When TX is selected, the next functions are made:
-Data transmission is activated
-If operation mode is continuous,
Operation mode is set to burst
-RF Information window is updated
Continuous mode radio button is disabled.
NOTE: Function is activated immediately; the Apply button is not needed.
Operation Mode group:
Continuous radio button (ALT+C):
When continuous selection is used,
-synthesizer is set to constant frequency
-synthesizer channel number is as given with Continuous Mode Channel selection
-transmitter power is not connected
-if Active Unit is RX, AGC is controlled
NOTE: Function is activated immediately; the Apply button is not needed.
Burst radio button (ALT+B):
When burst selection is used,
-synthesizer is controlled by using receiving/transmission/measuring synthesizer control
sequence
-synthesizer channel numbers are as given with Channel/Monitoring Channel selections
-if Active Unit is TX, data (selected with TX Data Type) is sent and the TX power is con-
nected
NOTE! Function is activated immediately; the Apply button is not needed.
TX Data Type drop list (ALT+D): With this value the data transmission pattern can be