User Guide

PAMS Technical Documentation Service Software
NSB-5
Issue 1 03/01 Nokia Mobile Phones Ltd. Page 43
DC power supply is set to 10.5 Volts.
Mount the service battery on the phone and connect the service battery with the phone
by the charger calibration cable.
Connect the service battery to the DC power supply.
Select the menu “Tuning and Energy Management Calibration”.
The following dialog box appears:
Select the OK button. The phone is set to local mode, and the energy management dialog
pops up.
Select settings:
2. Battery voltage
3. Charger voltage
4. Battery size
5. Battery temperature
6. Charge current
Press Run. (If the setting “Save without confirmation” is also selected, then steps 7 to 11
are not applicable.)
The following dialog box appears:
Select the Yes button.