User Guide

NSB-5
Service Software PAMS Technical Documentation
Page 42 Nokia Mobile Phones Ltd. Issue 1 03/01
Dialog is closed and tuning is not saved to phone.
After each value change the new value is sent to the phone.
The next automatic selections are made, and the RF Information window is updated
when the TX I/Q tuning function is ended:
-Band= GSM
-Active Unit= RX
-TX Power level= (Off)
-Operation Mode= Burst
Energy Management Calibration... command
This command opens the “Energy Management Calibration” dialog box:
Figure 19: Energy Management Calibration Dialog
A DC power supply, a service battery, and a 3-wire charger calibration cable is needed for
this calibration.
NOTE: The Energy Management Calibration process in WinTesla should only be used
when the factory calibration for some reason is no longer valid in the phone. The factory
calibration of the phone energy management parameters are more precise, thus it is pos-
sible to obtain better battery performance when the calibration has been performed in
the factory.
Activation Status Bar Text
Alt, T,E Initializing local mode...;
The Energy Management Calibration is performed in the following steps: